MTHTrains 4-6-0 Steam Freight/Passenger Set Instructions d'exploitation télécharger pdf (Page 14)

Tips on Using PFA

•You can terminate PFA at any time by turning off power to the track for 15 seconds.

•You do not have to be in Forward to use PFA. At the conclusion of the full sequence,

the train will pull away from the station in whatever direction you were going when you

activated the feature.

•You can use PFA even if you are double-heading with another engine. If the second

engine is not equipped with Proto-Sound 3.0, you must remember not to leave the

throttle at a high voltage level once you have stopped the engine to run the PFA.

Otherwise, the engine without PFA will begin vibrating on the track as its motors strain

to move the train, since they cannot be automatically disabled during the PFA cycle (or

if an original Proto-Sound engine, PFA are triggered differently and that engine's

motor-disable feature will not be active when you run PFA in Proto-Sound 3.0).

•PFA can be triggered from Neutral. It will operate the same as if triggered while in

motion except that, at the conclusion of the PFA, the engine will depart in the next

direction of travel, as opposed to the direction it was traveling before entering Neutral.

™

Proto-Coupler Operation

This locomotive is equipped with one or more coil-wound Proto-Couplers for

remote uncoupling action. Because Proto-Couplers are controlled through the

Proto-Sound 3.0 microprocessor, they do not require an uncoupling track section

or modification to your layout to function. You can fire a coupler from neutral or

while in motion. Use the code shown below (and in the chart on p. 28) to fire the

coupler(s).

Rear Coupler:

To fire the rear coupler, quickly tap the Bell button once followed by three quick taps

of the Horn button, allowing approximately ½ second to lapse between each quick

button press. The sound of the liftbar and air line depletion will play, and the knuckle

will be released.

Front Coupler:

To fire the front coupler (if your engine has one), quickly tap the Bell button once

followed by four quick taps of the Horn button, allowing approximately ½ second

to lapse between each quick button press. The sound of the liftbar and air line

depletion will play, and the knuckle will be released.

Horn Horn

Fire

Rear

Coupler

Horn

Bell

Horn Horn

Fire

Front

Coupler

Horn Horn

Bell

RailKing 4-6-0 Steam Freight/Passenger Set with Proto-Sound® 3.0

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

MTHTrains 4-6-0 Steam Freight/Passenger Set Instructions d'exploitation Page 14

Commentaires sur ces manuels