MTHTrains 4-6-0 Steam Freight/Passenger Set Guide de dépannage télécharger pdf (Page 11)

Freight Yard Sounds (FYS) or

Passenger Station Announcements (PSA):

Your engine is equipped with a sound package of either freight yard or passenger station

sounds that you can play. Each sequence described below will play as long as it is left

on, randomly generating sounds, but be sure to allow approximately 30 seconds

between the button pushes described below to allow the FYS/PSA sufficient time to

run through each sequence.

!To cue the sound system to play the FYS/PSA, press the PFA Button on the remote.

!Press the Direction button once to stop the engine. This will trigger the first sequence of

FYS/PSA. The reverse unit is temporarily disabled so that the train will not move as you

use the Direction button to trigger the sounds, and Proto-Sound 2.0 has disabled operator

control over the Horn/Whistle and Bell buttons until the full FYS/PSA sequence is

complete.

!After waiting about 30 seconds for that sequence to run, press the Direction button again

to trigger the second sequence of FYS/PSA.

!After about 30 seconds, press the Direction button again to trigger the third FYS/PSA

sequence.

!Again, after allowing about 30 seconds for that sequence to run, press the Direction button

one more time to trigger the fourth and final FYS/PSA sequence.

!The FYS/PSA will continue, and within a few seconds, the engine will start and move out

on its own at the current throttle setting, in the same direction it was traveling when you

began the sequence. Once the bell turns off, the operator regains control of the

transformer's Bell and Horn/Whistle buttons and can ring the bell or blow the

horn/whistle as usual.

Tips on Using FYS/PSA

!You can terminate FYS/PSA at any time by pressing the PFA Button on the remote.

!You do not have to be in Forward to use FYS/PSA. At the conclusion of the full

sequence, the train will pull away from the station in whatever direction you were

going when you activated the feature.

!FYS/PSA can be triggered from Neutral. It will operate the same as if triggered

while in motion except that, at the conclusion of the FYS/PSA, the engine will

depart in the next direction of travel, as opposed to the direction it was traveling

before entering Neutral.

Proto-Coupler™ Operation

This locomotive is equipped with one or more coil-wound Proto-Couplers for

remote uncoupling action. Because Proto-Couplers are controlled through the

Proto-Sound® 3.0 microprocessor, they do not require an uncoupling track section

or modification to your layout to function. You can fire a coupler from neutral or

while in motion.

RailKing 4-6-0 Steam Freight/Passenger Set with Proto-Sound® 3.0

Sound System Cued to Play

Freight Yard or Passenger

Station Sounds (FYS)/(PSA)

1st

Sequence

FYS/PSA

2nd

Sequence

FYS/PSA

3rd

Sequence

FYS/PSA

4th

Sequence

FYS/PSA

Operator

Controls

When Bell

Turns Off

PFA

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

MTHTrains 4-6-0 Steam Freight/Passenger Set Guide de dépannage Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires MTHTrains 4-6-0 Steam Freight/Passenger Set