MTHTrains 4-6-0 Steam Freight/Passenger Set Instructions d'exploitation télécharger pdf (Page 14)

If you experience poor or no smoke output when the smoke unit is on and has fluid,

check the wick to see if it has become hard, blackened, and unabsorbent around the

heating element. Remove the boiler as shown below. Remove the smoke unit inspection

cover from the locomotive's body (see right). After removing the chassis and inspection

cover screws, lift the inspection plate away and inspect the wick. If it is darkly

discolored and hard, it should be replaced. When priming new wick add 40 drops.

Locomotive Light Bulb Replacement

To replace the light bulb in the locomotive, follow the boiler removal instructions below.

Remove the four Phillips screws

from the chassis then lift the body

away from the chassis.

STEP

Running the engine without a primed

smoke unit may cause damage

Replace Headlight Bulb

STEP

Once the locomotive boiler has been removed

from its chassis, locate the bulb bracket as seen in

the illustration on the right and rotate the

headlight bulb counter-clockwise to remove.

RailKing 4-6-0 Steam Freight/Passenger Set with Proto-Sound® 2.0

Passenger Car Light Bulb Replacement

To replace the interior light bulbs, follow these steps.

1) To remove the shell

from chassis remove the

four screws located

underneath the trucks.

STEP

Remove these

four screws

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

MTHTrains 4-6-0 Steam Freight/Passenger Set Instructions d'exploitation Page 14