MTHTrains 4-6-0 Steam Freight/Passenger Set Instructions d'exploitation télécharger pdf (Page 10)

Front Coupler:

To fire the front coupler (if your engine has one), quickly tap the Bell button once

followed by four quick taps of the Whistle button, allowing approximately ½ second to

lapse between each quick button press. The sound of the liftbar and air line depletion will

play, and the knuckle will be released.

Speed Control:

M.T.H. engines equipped with Proto-Sound 2.0 have speed control capabilities that allow

the engine to maintain a constant speed up and down grades and around curves, much

like an automobile cruise control. You can add or drop cars on the run, and the engine

will maintain the speed you set.

While the engine is programmed to start with the speed control feature activated, you can

opt to turn it off. This means the engine's speed will fall as it labors up a hill and increase

as it travels downward. It is also affected by the addition or releasing of cars while on the

run. Because the engine will run more slowly at a given throttle voltage when speed

control is on than when it is off, you should adjust the throttle to a lower power level for

operation with speed control off to avoid high-speed derailments. When speed control is

off, the volume will drop to allow for better low voltage operation.

To turn speed control on and off, put the engine in neutral, then quickly tap the

transformer's whistle button one time then quickly tap the Bell button two times, allowing

approximately ½ second to lapse between each quick button press. Repeat the 1 whistle,

2 bells code to return it to the other condition. You will want to do this during the initial

neutral upon start-up if you ever couple this engine to another engine that is not equipped

with speed control to avoid damaging the motors in either engine. Each time you shut

down the engine completely, it will automatically turn speed control on.

Lock into a Direction:

You can lock your engine into a direction (forward, neutral, or reverse) so that it will not

change directions. To do this, put the engine into the direction you want (or into neutral

to lock it into neutral), run it at a very slow crawl (as slowly as it will move without

halting), and quickly but firmly tap the Whistle button once followed by three quick taps

of the Bell button, allowing approximately ½ second to lapse between each quick button

press. Two whistle blasts will indicate that the engine has made the change. The engine

will not change direction (including going into neutral) until you repeat the 1 whistle, 3

bells code to return the engine to its normal condition, even if the engine is kept without

power for extended periods of time.

Whistle Whistle

Fire

Front

Coupler

Whistle Whistle

Bell

Whistle

Place

Engine into

Neutral

Bell Bell

whistle

Place

Engine into

Desired

Direction

Whistle

Bell Bell Bell

Speed Control

Two Whistle Blasts

(indicates change is made)

Repeat to Return

to Normal Condition

Direction Lock

Two Whistle Blasts

(indicates change is made)

Repeat to Return

to Normal Condition

RailKing 4-6-0 Steam Freight/Passenger Set with Proto-Sound® 2.0

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

MTHTrains 4-6-0 Steam Freight/Passenger Set Instructions d'exploitation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires MTHTrains 4-6-0 Steam Freight/Passenger Set